Read this manual before you use this Nailer. Follow all safety warnings and instructions. If you are uncertain about the operation of the Nailer, call
7#33#21#20#19#30#32#34Seal Placement10
11For this and other Powernailer schematics, please visit the Powernail Parts Store at http://www.powernail.comPowernail FLEX Schematic76787972737177
POWERCLEATS LENGTH DETERMINATION CHARTThis chart will assist you in determining the proper length of Powercleats to use for various thicknesses of oo
13PROBLEM POSSIBLE CAUSE SOLUTION1Driving blade does not retract1. Zero or Low air pressureCheck air supply for 70 psi minimum to 110 psi maximum2. La
2Always wear approved front and side EYE PROTECTION when operating this Nailer. Others in the work area should also wear front and side EYE PROTECTION
ADAPTER FOOT LOCATING EAR3FLEX Foot Adjustment:Wood varies from one manufacturer to the next. The different wood proles may be due to height and len
4WARNING It is not necessary to hit the Nailer hard to activate it. Never hit the Nailer with excessive force or with the metal end of the mallet, thi
from turning while unscrewing the Jam Nut by holding the piston hex with the 1-1/8" box wrench supplied.6. Push out the 1/4" diameter blade
TO REPLACE THE SEALS:Plunger Seal Set (#32): 1. Remove the Teon® Seal and its O-ring expander from the Plunger groove using a bent paper clip or pick
Seal. Saturate the new felt Wiper Seal with oil.Return Cylinder O-Ring Gasket (#34): 1. Place a new O-Ring Gasket in the groove on top of the Return C
ITEM # PART NO. DESCRIPTION Qty Req’d Key Ref. Assy/Kit1 09-50P-3001 Body 1 F2 09-50P-3002 Cap 1 S3 09-445-29815 Handle - Extra Long 1 S/A A-54 09-445
ITEM # PART NO. DESCRIPTION QTY REQ’D Key/Ref Assy/Kit43 09-445-29741 1/8 X 5/8 Roll Pin (Gate) 2 S/A A-444 09-445-29742 1/4-20 X 7/8 SHCS (Xl - Handl
Comentários a estes Manuais